The short answer
There is no single price for an HVAC lead, and any article that gives one is quoting somebody else’s account. What a lead costs is set by two numbers the business owns: what a click costs for the service being advertised, and what share of those clicks turn into booked work.
Both numbers move so much across HVAC services that a figure quoted for the trade as a whole carries no information. The arithmetic below produces a figure for one business, which is the only version worth planning against.
Why there is no single HVAC lead price
Because the auction charges by search term, and HVAC search terms are not priced alike. These are United States costs per click from Ahrefs Keywords Explorer, pulled on 19 November 2026.
| HVAC search term | Monthly US searches | Cost per click |
|---|---|---|
| emergency hvac repair | 8,600 | $13.00 |
| furnace repair | 233,000 | $11.00 |
| ac repair near me | 161,000 | $9.00 |
| hvac repair near me | 133,000 | $5.00 |
| air conditioning installation | 47,000 | $3.50 |
| hvac installation | 92,000 | $0.90 |
| heating repair | 36,000 | $0.70 |
The spread from the cheapest term to the dearest is more than eighteen times. These are Ahrefs modelled estimates rather than invoiced prices, so read them as the shape of the auction rather than as a quote. The spread tracks the individual search term: heating repair sits at seventy cents while furnace repair, a near synonym for the same job, sits at eleven dollars. One published average covering all of them describes none of them.
How to work out your own cost per lead
Divide the cost of a click by the share of clicks that become a lead. A term costing nine dollars a click, on a page where one visitor in twenty makes contact, produces a lead at one hundred and eighty dollars. The same term on a page converting one in ten produces a lead at ninety.
Nothing about the advertising changed between those two outcomes. The page did. This is why the conversion rate is the half of the equation worth attention before any bid gets raised, and why what an HVAC website typically converts at matters more to the final figure than the click price does.
Then carry the arithmetic one step further. Multiply the cost per lead by the number of leads it takes to book one job. A lead price only means something next to the value of the work it eventually produces.
What moves the number up or down
The service being advertised
An emergency term can cost many times a planned one. The pattern does not hold by work type, though: in the table above, heating repair sits at seventy cents while furnace repair, a near synonym for the same job, sits at eleven dollars. The individual term sets the price, so the only safe reading is the one taken from the account.
How fast inbound calls are answered
A lead that rings out is paid for and lost. Response speed changes the effective cost per booked job without changing the advertising at all.
How tightly the targeting is drawn
Broad terms attract clicks from people shopping for information. Narrow terms cost more each and waste less. The cheaper click is not always the cheaper lead.
The same pattern runs through every trade. The plumbing version of this arithmetic is set out at what a workable cost per lead looks like for plumbing, and the channel choices behind it at HVAC lead generation strategy.
What the number is actually for
A cost per lead is a decision tool rather than a score. Once a business has its own figure, three decisions get easier and all three were guesses before.
Which service to put the budget behind
Run the arithmetic separately for repair work and for replacement work. The two produce different lead costs and different job values, and the service with the cheaper lead is often the one with the thinner margin. Comparing lead cost against job value, service by service, usually reorders the list a business started with.
Whether to raise the bid or fix the page
If the lead cost is high because clicks are expensive, raising the bid makes it worse. If it is high because the page converts poorly, the bid is not the problem at all. Separating the two stops money going into an auction that was never the constraint.
When to stop
A service where the cost per booked job exceeds what the job pays is not a campaign that needs more budget. It is a campaign that needs a narrower target or a different service behind it. Knowing the figure is what makes that call possible before the quarter ends rather than after it.
Where bought leads fit
Shared leads from a marketplace carry a different problem. The price is visible and the competition is not: the same inquiry often reaches several contractors, so the quoted price per lead and the real cost per booked job are different numbers.
Bought leads still have a place. They are simply harder to compare, because a marketplace lead and a search lead have to be judged on booked work rather than on the price written on the invoice. Take two illustrative cases. A marketplace lead at forty dollars that books one time in twenty costs eight hundred dollars a job. A search lead at one hundred and eighty that books one time in three costs five hundred and forty. On those booking rates the cheaper invoice produced the dearer job. Change the booking rates and the result flips, which is exactly why the invoice price on its own settles nothing.
The comparison only works when both channels are measured the same way, which means recording the source of every booked job rather than every inquiry.
Operators who want this worked through against their own account numbers can book a working call with Magister Digital.
FAQ
How much do HVAC companies pay for leads?
It depends on which service the lead came from and how the business acquired it. A click on an emergency repair term costs many times what a click on a heating repair term costs, and the booking rate behind it decides the rest. Any figure quoted without naming the term and the booking rate is describing somebody else’s account.
How much should I pay per lead?
No more than the profit on the job multiplied by the share of leads that book. A business keeping forty percent of a two thousand dollar replacement clears eight hundred dollars, and if one lead in four books, the ceiling is two hundred dollars a lead. Run the same sum on low margin repair work and the ceiling falls sharply. The number comes out of the business’s own margin and booking rate, which is why an industry average cannot supply it.
How do I get HVAC leads for free?
Organic search, the Google Business Profile and repeat customers carry no cost per lead, though they carry a cost in time and in content. They are slower to build than paid search and harder to turn up on demand, which is why most operators run both.
